http://groups.google.com/group/alt.autos.nissan?hl=en
alt.autos.nissan@googlegroups.com
Today's topics:
* Heater Dial Malfunctioning (1997 Sentra) - 5 messages, 4 authors
http://groups.google.com/group/alt.autos.nissan/t/12dad1c73410e22e?hl=en
* Ahmadinejad punished my Christian mother's rapist when the president was
mayor of Tehran! - 1 messages, 1 author
http://groups.google.com/group/alt.autos.nissan/t/5b0291c705a88165?hl=en
==============================================================================
TOPIC: Heater Dial Malfunctioning (1997 Sentra)
http://groups.google.com/group/alt.autos.nissan/t/12dad1c73410e22e?hl=en
==============================================================================
== 1 of 5 ==
Date: Mon, Oct 11 2010 7:57 pm
From: Plague Boy
On 10/11/10 4:19 PM, Joe AutoDrill wrote:
>> Usually it will be the resistor pack that controls the fan speeds, though
>> I
>> have seen the same symptom caused by burned contacts in the switch.
>>
>> The resistor pack will be a little block screwed into the air box, behind
>> the glove box. Look for a connector with four or five wires. Its not the
>> end at the fan, but out by itself on the air box. Usually held in by a
>> screw on each end. You should be able to pick one up from the local junk
>> yard relatively cheap.
>>
>> If that doesn't fix it, take apart the dash switch and look for burned
>> contacts. If its the switch, it'll be obvious when you take it apart.
>> Repair by replacing the switch (same junk yard, probably from the same
>> car).
>
> Excellent advice...
>
> Did I mention that junk yards are virtually non-existant in NJ? :(
>
> I'll find the part that is bad, maybe order *both* in case from an on-line
> junk yard and pray the electrical gremlins don't strike my used part.
My '92 Sentra has 178K on it and still runs great, and no, it was not
"lovingly maintained" by it's previous owner. I suspect the rust will
make it un-inspect-able in the next year or so, but it doesn't owe me
anything.
The first year I got it, the blower resistor failed. I bought a new
one, locally I think, for about $25.00. Personally, I would not bother
with a used one, you (or somebody, maybe me) may still be driving this
car in five years. It's not a lot of work to change the resistor, but
still.....
The switch, I can't say. I would put in a new resistor and see if that
fixes it.
PB
== 2 of 5 ==
Date: Tues, Oct 12 2010 4:58 am
From: "D."
I had the same problem with
my Frontier . E.Meyer was right
on with his advice .
I would not waste time with
a used one as it could also be
no good .
D.
"Joe AutoDrill" <autodrill@yunx.com> wrote in message
news:0UDso.7325$W96.1113@newsfe08.iad...
> Okay, so it's getting a bit colder here. Hit 38 the night before last and
> we may actually have to turn the heat on in the house soon.
>
> ...But I've got a new issue with the car that just won't die. The twist
> knob that adjusts the fan setting for AC, fan or heat works great! ...But
> the contacts must be wearing off or a fuse gone because setting 1 and 2 do
> not work. That means when I want just a little bit of heat once the
> engine
> is warm, I can choose 3 or 4 or turn down the temperature.
>
> Anyone know what causes this to happen and maybe how to fix it?
>
> I was fine with 1 not working. ...But now that 2 has disappeared, I'm
> starting to worry about winter if 3 and 4 go bad too... That would force
> me
> to bundle up quite a bit and/or get a new car or 12V heater...
>
> If it matters, it is a 1997 Nissan Sentra with 207,000 on it. Other than
> minor stuff like this, it runs like a top and doesn't eat a bit of oil.
> The back doors are stiff from never taking on passengers and I'm convinced
> it'll be another car, a deer or rust that eventually makes this commuter's
> dream car die.
>
> ...Or lack of heat on a 10 degree morning!
>
> Regards,
> Joe Agro, Jr.
> (800) 871-5022
> 01.908.542.0244
> Automatic / Pneumatic Drills: http://www.AutoDrill.com
> Multiple Spindle Drills: http://www.Multi-Drill.com
> Production Tapping: http://Production-Tapping-Equipment.com/
> Flagship Site: http://www.Drill-N-Tap.com
> VIDEOS: http://www.youtube.com/user/AutoDrill
> TWITTER: http://twitter.com/AutoDrill
> FACEBOOK: http://tinyurl.com/AutoDrill-Facebook
>
> V8013-R
>
>
>
>
== 3 of 5 ==
Date: Tues, Oct 12 2010 9:28 am
From: Jim Yanik
"Joe AutoDrill" <autodrill@yunx.com> wrote in
news:RjKso.1783$hb.1492@newsfe12.iad:
>> Usually it will be the resistor pack that controls the fan speeds,
>> though I
>> have seen the same symptom caused by burned contacts in the switch.
>>
>> The resistor pack will be a little block screwed into the air box,
>> behind the glove box. Look for a connector with four or five wires.
>> Its not the end at the fan, but out by itself on the air box.
>> Usually held in by a screw on each end. You should be able to pick
>> one up from the local junk yard relatively cheap.
>>
>> If that doesn't fix it, take apart the dash switch and look for
>> burned contacts. If its the switch, it'll be obvious when you take
>> it apart. Repair by replacing the switch (same junk yard, probably
>> from the same car).
>
> Excellent advice...
>
> Did I mention that junk yards are virtually non-existant in NJ? :(
>
> I'll find the part that is bad, maybe order *both* in case from an
> on-line junk yard and pray the electrical gremlins don't strike my
> used part.
if you're ordering online,check out new parts prices,too.
there may not be that much difference,especially if you can get aftermarket
parts.
I saved hundreds on a MAF sensor for my 03 Sentra SpecV by looking around
and finding the sensor itself without the housing that most places include
as part of the MAF unit. $400 for the sensor and housing,$80 for sensor
alone. Crazy.
--
Jim Yanik
jyanik
at
localnet
dot com
== 4 of 5 ==
Date: Tues, Oct 12 2010 9:34 am
From: "Joe AutoDrill"
Thanks for all the great tips folks. I'll have to find the time to do it
now, but at least I have an avenue to hopeful repair. :)
Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills: http://www.AutoDrill.com
Multiple Spindle Drills: http://www.Multi-Drill.com
Production Tapping: http://Production-Tapping-Equipment.com/
Flagship Site: http://www.Drill-N-Tap.com
VIDEOS: http://www.youtube.com/user/AutoDrill
TWITTER: http://twitter.com/AutoDrill
FACEBOOK: http://tinyurl.com/AutoDrill-Facebook
V8013-R
== 5 of 5 ==
Date: Tues, Oct 12 2010 9:34 am
From: "Joe AutoDrill"
Thanks for all the great tips folks. I'll have to find the time to do it
now, but at least I have an avenue to hopeful repair. :)
Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills: http://www.AutoDrill.com
Multiple Spindle Drills: http://www.Multi-Drill.com
Production Tapping: http://Production-Tapping-Equipment.com/
Flagship Site: http://www.Drill-N-Tap.com
VIDEOS: http://www.youtube.com/user/AutoDrill
TWITTER: http://twitter.com/AutoDrill
FACEBOOK: http://tinyurl.com/AutoDrill-Facebook
V8013-R
==============================================================================
TOPIC: Ahmadinejad punished my Christian mother's rapist when the president
was mayor of Tehran!
http://groups.google.com/group/alt.autos.nissan/t/5b0291c705a88165?hl=en
==============================================================================
== 1 of 1 ==
Date: Tues, Oct 12 2010 11:32 am
From: Dzag
On Oct 9, 2:11 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
> On Sep 30, 3:28 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
>
>
> > On Sep 25, 1:59 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
> > > On Sep 24, 12:54 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
> > > > On Sep 20, 10:24 am, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
> > > > > On Sep 18, 1:55 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
> > > > > > On Sep 11, 3:43 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
> > > > > > > On Sep 11, 3:37 pm, Dzag <Dzaghigyavor...@yahoo.com> wrote:
>
> > > > > > > > My last name is Yavorian! I am an armenian christian and I was born in
> > > > > > > > Tehran in the Abbas Abad district. I lived with my beautiful mother
> > > > > > > > there back in 2004 when President Ahmadinejad was just mayor of the
> > > > > > > > city. My mother had proof the Shiite muslim man who raped her was very
> > > > > > > > guilty of doing so but he was prominent (he had friends and family in
> > > > > > > > the local police department among other places) and especially since
> > > > > > > > we were Christians our case was considered extra-doubtful to be made
> > > > > > > > and not even an arrest could be made! Through a male friend of mine I
> > > > > > > > got a brief personal audience with Mayor Ahmadinejad! He was busy, I
> > > > > > > > could tell by the paper work on his desk, but he patiently listened to
> > > > > > > > me all the same, looked at the proof I presented of the rape of my
> > > > > > > > mother and decided to have the local man arrested! He used his
> > > > > > > > influence to get the case fairly presented in a court of law and the
> > > > > > > > bad man/rapist got 25 years for since charges as breaking an entry! My
> > > > > > > > mother rests easy now thanks to Ahmadinejad's fairness as mayor!
>
> > > > > > - Show quoted text -
>
> I owe him so much!- Hide quoted text -
>
> - Show quoted text -- Hide quoted text -
>
> - Show quoted text -
==============================================================================
You received this message because you are subscribed to the Google Groups "alt.autos.nissan"
group.
To post to this group, visit http://groups.google.com/group/alt.autos.nissan?hl=en
To unsubscribe from this group, send email to alt.autos.nissan+unsubscribe@googlegroups.com
To change the way you get mail from this group, visit:
http://groups.google.com/group/alt.autos.nissan/subscribe?hl=en
To report abuse, send email explaining the problem to abuse@googlegroups.com
==============================================================================
Google Groups: http://groups.google.com/?hl=en
No comments:
Post a Comment